1. Drain engine oil
2. Replace oil filter with premium filter
3. Lube all greasable joints
4. Inspect belts and hoses
5. Check for leaks, inspect condition of and top off all fluids
6. Inspect suspension and steering components
7. Inspect exhaust system
8. Inspect all drive train components
9. Inspect tire wear and check pressure
10. Inspect air filter and if needed replace with premium filter
11. Conduct general inspection under the hood and under the vehicle for any possible faults and needed repairs
12. Check all lights
13. Road test

COOLING SYSTEM SERVICE:

1. Inspect condition of all cooling system components:  radiator, heater core, hoses, gaskets, and seals
2. Drain cooling system
3. Two stage flush:  first with high pressure tap water, second with distilled water
4. Leak test and vacuum fill cooling system with new antifreeze, distilled water, and rust inhibiting treatment
5. Road test

AUTOMATIC TRANSMISSION SERVICE:

1. Inspect transmission, transmission cooler, and lines for leaks
2. Drain transmission fluid
3. Remove transmission pan and filter
4. Inspect filter and pan for excessive debris
5. Install new filter
6. Install transmission pan with new gasket
7. Fill transmission with factory approved fluid
8. Road test

BRAKE FLUID FLUSH:

1. Inspect brake fluid system for leaks
2. Evacuate brake fluid reservoir and refill with factory approved fluid
3. Bleed fresh fluid through all components:  master cylinder, antilock controller, lines, calipers, and wheel cylinders (if drums)
4. (additional charge) Inspect brake pads and rotors
5. Road test

MOTORVAC® CARBON CLEAN®:

1. “Fog” throttle body and intake manifold with safe and effective carbon cleaning detergent
2. Connect vehicle’s engine to MotorVac machine and run the engine for one hour on a 2:1 mixture of gasoline and carbon cleaning detergent
3. Disconnect MotorVac machine
4. Road test

TUNE-UP:

1. Change spark plugs
2. Check compression
3. Inspect distributor cap and rotor (if equipped)
4. Scope test ignition system
5. Inspect belts and hoses, replace as needed
6. Check for leaks, inspect condition of and top off all fluids
7. Conduct a general inspection under the hood for any possible wire faults and needed repairs
8. Check all vehicle lights
9. Road test